The machine is mainly used for the roll bending processing of aluminum composite panel, pure aluminum plate, stainless steel board and steel bar.  The NC machine thoroughly solves the problems of only driving the upper roller, and the difficulty of rolling thinner stave and can realize greater  declivity of the upper roller and side roller through the change of roller and then roll conical barrel with huger coning; it is with clear operation  interface and simple and convenient but precise operation. Therefore, it is one kind of product which can make you obtain high production efficiency,  reliability and competitiveness.            Four-roller hydraulic numerical controlled rolling machine has the function of double-end pre-bending. It is the machine with the best performance in  the international market; it has advantages not possessed by any other machine; the operator only needs determining the position of the side roller,  and it will begin to make the fore-end pre-bending of bar material automatically with shortest straightway left; unlike single-side pre-bending rolling  machine which needs the working procedures of sheet material moving out,U-turn, and re-feeding, etc, the four-roller hydraulic numerical controlled  rolling machine can finish all the procedures only by passing once.Any end of two lower side rollers and bottom roller can go up and down separately; the bottom roller is below the top roller, the accuracy is very high, it can bend many different radius arc on one panel.The oil cylinder controls the three rollers independently, the hydraulic motor drives gear box as three rollers linkage, and the top roller will adjust the rotating speed to match the two lower rollers as per material thickness, the bottom roller is driven to rotate together

  

Model and parameter	KS-WB2505/WB3005    Manual Plate Bending Machine
Maximum thickness of bending	6mm
Maximum width of bending	2500mm/3000mm
bending speed	7.16m/min
Working mode	Manual adjustment
Working voltage	380VAC/50HZ
Driving mode	Motor drive the gearbox move
Power of main motor	3.5kW
Overall Dimension (L*W*H)	4300x1200x1330mm
Weight of machine	1200Kg
Matching device	Equipped with feed table, loading station and feeding device, it can become an automatic roll bending centre with high efficiency